Mitsubishi Electric FR-D720S SC EC, Инструкция по эксплуатации

Страница: 495 / 512

Appendix Parameter list with instruction codes
FR-D700 SC EC A - 11
A.4 Parameter list with instruction codes
In the initial setting status, simple mode parameters and extended parameters can be displayed.
Set Pr. 160 as required. So check the setting of Pr. 160 if parameters are not shown or change
the setting of Pr. 160 to lock parameters.
Parameter Name
Initial
Value Setting
Range
Remarks
160
Extended function
display selection
0
0
Simple mode and extended mode
parameters can be displayed.
9999
Only the simple mode parameters can be dis-
played.
Tab. A-4: Settings of parameter 160
NOTES The parameters marked are the simple mode parameters.
The parameters marked with in the table allow its setting to be changed during ope-
ration even if "0" (initial value) is set in Pr. 77 "Parameter write selection".
The instruction codes (hexadecimal) for "read" and "write" on the right of the parameter
number are those used to set the parameter via communication. "Extended" indicates the
setting of the extended link parameter (refer to section 6.18).
The data code is contained in
the table columns to the right next to the parameter number.
The symbols in the table have the following meanings:
✔
: Setting the parameter is possible for this operation mode.
—: Setting the parameter is impossible for this operation mode.
Function
Para-
meter
Instruction Code
Name
Control Mode-based
Correspondence Table
Refer
to Page
Customer
Setting
Read
Write
Extended
V/f Control
General-
Purpose
magnetic
Flux Vector
Control
Basic
functions
0 00 80 0 Torque boost
✔
— 6-26
1 01 81 0 Maximum frequency
✔ ✔
6-40
2 02 82 0 Minimum frequency
✔ ✔
3 03 83 0 Base frequency
✔
— 6-44
4 04 84 0
Multi-speed setting
RH
✔ ✔
6-48 5 05 85 0 RM
✔ ✔
6 06 86 0 RL
✔ ✔
7 07 87 0 Acceleration time
✔ ✔
6-59
8 08 88 0 Deceleration time
✔ ✔
9 09 89 0 Electronic thermal O/L relay
✔ ✔
6-66
Tab. A-5: Parameter list with instruction codes (1)