Mitsubishi Electric FR-D720S SC EC, Инструкция по эксплуатации

Страница: 407 / 512

Parameter Special operation
FR-D700 SC EC 6 - 257
Dancer control overview
Performs dancer control by setting "40" to "43" in Pr. 128 "PID action selection". The main speed
command is the speed command of each operation mode (external, PU, Network). Performs
PID control by the position detection signal of the dancer roller, then the result is added to the
main speed command. For acceleration/deceleration of the main speed, set the acceleration
time in Pr. 44 "Second acceleration/deceleration time" and the deceleration time in Pr. 45 "Sec-
ond deceleration time".
Set 0s normally to Pr. 7 "Acceleration time" and Pr. 8 "Deceleration time". When the Pr. 7 and
Pr. 8 setting is large, response of dancer control during acceleration/deceleration is slow.
Connection diagram
The following figure shows a typical application example:
The main speed command differs according to each operation mode (external, PU, network).
The used input signal terminal changes depending on the Pr. 178 to Pr. 182 setting.
The used output signal terminal changes depending on the Pr. 190, Pr. 192 or Pr. 197 setting.
The AU signal need not be input.
I001841E
Fig. 6-132: Signal overlay during dancer control
I002004C
Fig. 6-133: Example in source logic
ON
Output frequency
Main
speed
Output frequency
Tme
PID adding value
M
STR
STF
SE
RH (X14)
PC
L1
U
L2 V
L3
W
4
5
10
2
(FUP) RUN
Power
supply
Forward rotation
Reverse rotation
PID control selection
Potentiometer
1k
Ω
, 1–2W
(Main speed
command)
Upper limit (FUP)
Output signal common
Pr. 128 = 41
Pr. 182 = 14
Pr. 190 = 15
Feedback value of
dancer roll position