Dell C9000 series, Справочное руководство

Страница: 681 / 2286

Usage Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
interfaces. It is also acts as defaults when the link-level flow control is enabled on one
or more interfaces.
To enable DCB, do one of the following:
• Apply the
dcb-input policy
command with the
no pfc-mode
command on
to all the interfaces.
• Disable flow-control on all of the interfaces.
Enables priority flow control or enhance transmission selection on interface.
Related
Commands dcb <ets | pfc> enable — enable priority flow control or enhanced transmission
selection on interface.
PFC Commands
The following PFC commands are supported on the Dell Networking OS.
clear hardware pfc-nodrop-priority
Clear the drop statistics.
Syntax
clear hardware pfc-nodrop-priority l2-dlf drops stack-unit stack-
unit-number port-set port-pipe
Parameters
stack-unit stack-
unit-number
Enter the keywords
stack-unit
and the stack unit number.
The range is from 0 to 5.
port-set port-pipe Enter the keywords
port-set
and port-pipe number. The port-
pipe number is 0.
Command Modes
EXEC
EXEC Privilege
Command History
Version Description
9.10(0.0) Introduced on the C9010, S6000, S6000–ON, Z9100–ON and
S6100–ON.
Related
Commands
pfc-nodrop-priority l2-dlf drop — configures to drop the unknown unicast packets
flooding on lossless priorities.
Data Center Bridging (DCB) 681