Dell C9000 series, Справочное руководство

Страница: 1899 / 2286

Version Description
6.2.1.1 Introduced on the E-Series.
Usage Information You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the
network
command
specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
C9000 Series
Syntax
offset-list prefix-list-name {in | out} offset [ interface ]
To delete an offset list, use the
no offset-list prefix-list-name {in | out}
offset [ interface ]
command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine which
incoming routes are modified.
offset Enter a number from zero (0) to 16 to be applied to the
incoming route metric matching the access list specified. If you
set an offset value to zero (0), no action is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from 1
to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
Routing Information Protocol (RIP) 1899