Dell C9000 series, Справочное руководство

Страница: 1788 / 2286

Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To apply dot1p-queue-mapping, use the
service-class dynamic dot1p
command.
Use this command in Configuration Terminal Batch mode to apply the dot1p-queue-
mapping in a dual-homing setup.
Related
Commands show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on
the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode
entry.
C9000 Series
Syntax
service-class dynamic dot1p
To return to the default setting, use the
no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the
service-class
dynamic dot1p
command. The default mapping is as follows:
Quality of Service (QoS) 1788