Dell C9000 series, Справочное руководство

Страница: 102 / 2286

To return to the default setting, use the
no ip tftp source-interface
interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword
loopback
then a number from zero (0) to 16383.
• For a Port Channel, enter the keyword
port-channel
then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4820T.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Control and Monitoring 102