Dell C9000 series, Справочное руководство

Страница: 77 / 2286

Usage Information For the new settings to take effect, save the new CAM settings to the startup-config
(
write-mem
or
copy run start
) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires four blocks
and these blocks cannot be reallocated. The total number of blocks must be equal to
12. The
ipv4acl
profile range is from 0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.
Ranges for the CAM profiles are from 1 to 10, except for the
ipv6acl
profile which is
from 0 to 10. The
ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the
reload
conditional nvram-cfg-change
command.
You can use the
cam-acl default
command in Configuration Terminal Batch mode
to reset ACL CAM entries to default settings in a dual-homing setup.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
C9000 Series
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword
all
to enable CAM audit on all line cards.
ipv4-fib Enter the keyword
ipv4-fib
to designate the CAM audit on the
IPv4 forwarding entries.
interval time-in-
minutes
Enter the keyword
interval
followed by the frequency in
minutes of the CAM audit. Range: 5 to 1440 minutes (24 hours).
Default:
60 minutes .
Defaults Disabled
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
Control and Monitoring 77