Dell C9000 series, Справочное руководство

Страница: 385 / 2286

Version Description
6.1.1.0 Introduced on the E-Series.
Usage Information If you configure the
set next-hop
command, its configuration takes precedence
over the
neighbor next-hop-self
command in the ROUTER BGP mode.
If you configure the
set next-hop
command with the interface’s IP address (either
Loopback or physical), the software declares the route unreachable.
Related
Commands
match ip next-hop — redistributes routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
C9000 Series
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the
no set origin
command.
Parameters
egp Enter the keyword
egp
to set routes originating from outside the
local AS.
igp Enter the keyword
igp
to set routes originating within the same
AS.
incomplete Enter the keyword
incomplete
to set routes with incomplete
routing information.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Access Control Lists (ACL) 385