neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
C9000 Series
Syntax
neighbor {
ipv4-address
|
peer-group-name
} fall-over
To disable, use the
no neighbor {
ipv4-address
|
peer-group-name
} fall-
over
command.
Parameters
ipv4-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
Defaults
Disabled.
Command Modes
ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
7.4.1.0
Introduced
Usage Information When you enable failover, BGP keeps track of IP or IPv6 ability to reach the peer
remote address and the peer local address. Whenever either address becomes
unreachable (for example, no active route exists in the routing table for the peer IP or
IPv6 destination/local address), BGP brings down the session with the peer.
Related
Commands
— displays information on the BGP neighbors.
Border Gateway Protocol
471
Содержание C9000 series
