Dell C9000 series, Справочное руководство

Страница: 2182 / 2286

interface-type
interface-number
Enter the interface type, followed by the type, slot and port
information.
Defaults None.
Command Modes INTERFACE TUNNEL
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000 and Z9000.
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information The ip unnumbered command fails in two conditions:
• If the logical ip address is configured.
• If Tunnel mode is ipv6ip (where ip address over tunnel interface is not possible).
To ping the unnumbered tunnels, the logical address route information must be
present at both the ends.
NOTE: The
ipv6 unnumbered
command can specify an interface name that
does not exist or does not have a configured IPv6 address. The tunnel interface is
not changed to operationally up until the logical ip address is identified from one
of the address family.
tunnel allow-remote
Configure an IPv4 or IPv6 address or prefix whose tunneled packets are accepted for decapsulation. If you do
not configure allow-remote entries, tunneled packets from any remote peer address is accepted.
This feature is supported on Dell Networking OS.
C9000 Series
Syntax tunnel allow-remote
{ ip-address | ipv6-address } [ mask ]
To delete a configured allow-remote entry use the no
tunnel allow-remote
command. Any specified address/mask values must match an existing entry for the
delete to succeed. If the address and mask are not specified, this command deletes all
allow-remote entries.
Tunneling Commands 2182