Dell C9000 series, Справочное руководство

Страница: 1720 / 2286

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage Information Before you provision a port extender, enable the extended bridge feature using the
feature extended—bridge
command. The
pe provision pe-id
command
logically pre-provisions or adds a port extender (PE) even when the PE is not physically
connected to the switch. The port extender ID (
pe-id ) range is from 0 to 255.
After provisioning a PE using the
pe provision pe-id
, you can provision a stack
unit using the
stack-unit
command.
You can provision a port extender connected in a Dual-Homing setup from the
Configuration Terminal Batch mode.
To de-provision a port extender, use the
no pe provision pe-id
command.
NOTE: You must ensure that the port extender units are offline before you issue
the
no pe provision
command.
Example
DELL(conf)# pe provision 10
DELL(conf-pe-10)#
DELL(conf)# no pe provision 10
Related
Commands
• feature extended-bridge
• stack unit
• show pe
show config
Display the PE provision configuration details.
C9000 Series
Syntax
show config
Command Modes PE CONFIG (conf-pe- pe-id )
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
Port Extenders (PE) 1720