Dell C9000 series, Справочное руководство

Страница: 1022 / 2286

If a port extender (PE) is provisioned, cascade LAGs are created automatically (auto-
LAGs). You cannot configure the port-channel created through the auto-LAG. The
range for the port-channel created through auto-LAG is from 257 to 513.
If the line card is in a Jumbo mode chassis, you can also configure the
mtu
and
ip mtu
commands. The Link MTU and IP MTU values configured on the channel members
must be greater than the Link MTU and IP MTU values configured on the Port Channel
interface.
NOTE: In a Jumbo-enabled system, all members of a Port Channel must be
configured with the same link MTU values and the same IP MTU values.
Example
Dell(conf)# int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
channel-member — adds a physical interface to the LAG.
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface null — configures a null interface.
interface vlan — configures a VLAN.
shutdown — disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG
to be also in “oper up” status.
C9000 Series
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up”
status. The range is from 1 to 16. The default is
1 .
Defaults 1
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Interfaces 1022