Dell C9000 series, Справочное руководство

Страница: 300 / 2286

Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
non-contiguous.
any Enter the keyword
any
to specify that all routes are subject to
the filter.
host ip-address Enter the keyword
host
then the IP address to specify a host IP
address.
dscp Enter this keyword
dscp
to deny a packet based on the DSCP
value. The range is from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
command)
port port
Enter the application layer port number. Enter two port numbers
if using the range logical operand. The range is from 0 to 65535.
destination Enter the IP address of the network or host to which the packets
are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
non-contiguous.
count (OPTIONAL) Enter the keyword
count
to count packets
processed by the filter.
bytes (OPTIONAL) Enter the keyword
byte
to count bytes processed
by the filter.
log (OPTIONAL) Enter the keyword
log
to include ACL matches in
the log.
order (OPTIONAL) Enter the keyword
order
to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority) If you did not use the keyword
order
, the
ACLs have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL in
which you are creating the rule is applied to the monitored
interface. For more information, refer to the “Flow-based
Access Control Lists (ACL) 300