Dell C9000 series, Справочное руководство

Страница: 1648 / 2286

rootguard Enter the keyword
rootguard
to enable root guard on a PVST+
port or port-channel interface.
Defaults Not configured.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.2.1 Introduced the
loopguard
and
rootguard
options on the E-
Series TeraScale, C-Series, and S-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced the hardware
shutdown-on-violation
option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the optional Bridge Port Data Unit (BPDU) guard.
6.2.1.1 Introduced.
Usage Information The BPDU guard option prevents the port from participating in an active STP topology
in case a BPDU appears on a port unintentionally, or is misconfigured, or is subject to a
DOS attack. This option places the port into the Error Disable state if a BPDU appears,
and a message is logged so that the administrator can take corrective action.
NOTE: A port configured as an edge port, on a PVST switch, immediately
transitions to the forwarding state. Only ports connected to end-hosts should be
configured as an edge port. Consider an edge port similar to a port with a
spanning-tree portfast enabled.
If you do not enable
shutdown-on-violation
, BPDUs are still sent to the route
process module (RPM) CPU.
You cannot enable
root guard
and
loop guard
at the same time on a port. For
example, if you configure
loop guard
on a port on which
root guard
is already
configured, the following error message is displayed:
% Error: RootGuard is
configured. Cannot configure LoopGuard
.
Per-VLAN Spanning Tree Plus (PVST+) 1648