Dell C9000 series, Справочное руководство

Страница: 2172 / 2286

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added IPv6 support.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information You can configure multiple time-serving hosts (up to 250). From these time-serving
hosts, the system chooses one NTP host with which to synchronize. To determine
which server was selected, use the
show ntp associations
command.
Because many polls to NTP hosts can impact network performance, Dell Networking
recommends limiting the number of hosts configured.
Related
Commands show ntp associations — displays the NTP servers configured and their status.
ntp source
Specify an interface’s IP address to be included in the NTP packets.
C9000 Series
Syntax
ntp source interface
To delete the configuration, use the
no ntp source
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword
loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword
lag
then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
System Time and Date 2172