neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
C9000 Series
Syntax
neighbor {
ipv6-address
|
peer-group-name
} ebgp-multihop [
ttl
]
To disallow and disconnect connections, use the
no neighbor {
ipv6-address
|
peer-group-name
} ebgp-multihop [
ttl
]
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE:
The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name
Enter the name of the peer group.
ttl
(OPTIONAL) Enter the number of hops as the time to live (ttl)
value. The range is 1 to 255. The default is
255
.
Defaults
Disabled.
Command Modes
ROUTER BGP
Command History
Version
Description
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.2.1.0
Introduced on the E-Series ExaScale.
7.4.1.0
Introduced
Usage Information To prevent loops, the
neighbor ebgp-multihop
command does not install default
routes of the multihop peer. Networks not directly connected are not considered valid
for best path selection.
neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
C9000 Series
Syntax
neighbor {
ipv6-address
|
peer-group-name
} fall-over
Border Gateway Protocol
602
Содержание C9000 series
