To use the closest interface, use the
no neighbor {
ip-address
|
peer-group-
name
} update-source
interface
command.
Parameters
ip-address
Enter the IP address of the peer router in dotted decimal format.
peer-group-name
Enter the name of the peer group to disable all routers within
the peer group.
interface
Enter the keyword
loopback
then a number of the Loopback
interface. The range is from 0 to 16383.
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced ont he C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage Information Loopback interfaces are up constantly and the BGP session may need one interface
constantly up to stabilize the session. The
neighbor update-source
command is
not necessary for directly connected internal BGP sessions.
neighbor weight
Assign a weight to the neighbor connection, which is used to determine the best path.
C9000 Series
Syntax
neighbor {
ip-address
|
peer-group-name
} weight
weight
To remove a weight value, use the
no neighbor {
ip-address
|
peer-group-
name
} weight
command.
Border Gateway Protocol
492
Содержание C9000 series
