Dell C9000 series, Справочное руководство

Страница: 2202 / 2286

To disable upstream-link tracking without deleting the uplink-state group, use the
no
enable
command in uplink-state-group configuration mode.
Example
Dell(conf)#uplink-state-group 16
Dell(conf-uplink-state-group-16)#Dec 3 00:46:45: %SYSTEM:CP
%IFMGR-5-ASTATE_UP: Changed uplink state group
Admin state to up: Group 16
Related
Commands
• show running-config uplink-state-group — displays the current configuration of
one or more uplink-state groups.
• show uplink-state-group — displays the status information on a specified uplink-
state group or all groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
C9000 Series
Syntax
upstream interface
To delete an upstream interface, use the
no upstream interface
command.
Parameters
interface Enter one of the following interface types:
• 10-Gigabit Ethernet:
tengigabitethernet { slot/port
| slot/port-range }
• 40-Gigabit Ethernet:
fortyGigE { slot/port | slot/
port-range }
• Port channel:
port-channel { 1-512 | port-
channel-range }
Where
port-range
and
port-channel-range
specify a range
of ports separated by a dash (-) and/or individual ports/port
channels in any order; for example:
tengigabitethernet
1/1-2,5,9,11-12 port-channel 1-3,5
. A comma is
required to separate each port and port-range entry.
Defaults none
Command Modes UPLINK-STATE-GROUP
Uplink Failure Detection (UFD) 2202