Santerno Sinus M, User Manual

Page: 58 / 219

7-8
LED
display
Parameter
name
Min/Max
range
Description
Factory
defaults
Adj.
during
run
F59 [Stall
prevention
select]
0 ~ 7 This parameter stops accelerating ramp
during acceleration, decreases the
frequency during constant speed and
stops decelerating ramp during
deceleration.
0 X
During
Decel
During
constant run
During
Accel
Bit 2 Bit 1 Bit 0
0 - - -
1 - -

2 -

-
3 -
 
4

- -
5

-

6
 
-
7
  
F60 [Stall
prevention
level]
30 ~ 200
[%]
This parameter sets the amount of
current to activate stall prevention
function during Acceleration, Constant
speed or Deceleration.
The set value is the percentage of H33-
[Motor rated current].
150 X
F61 [When Stall
prevention
during
deceleration,
voltage limit
select]
0~1 In Stall prevention run during
deceleration, select 1if you want to limit
output voltage.
F63 [Save
up/down
frequency]
0 ~ 1 This parameter determines whether to
save the specified frequency during
up/down operation.
When 1 is selected, the up/down
frequency is saved in F64.
0 X
F64
1)
[Saved
up/down
frequency]
0 ~ 400
[Hz]
If “Save up/down frequency” is selected in
F63, this parameter shows the frequency
before the inverter stops or decelerates.
0 X
F65 [Up-down
mode select]
0~2 You can select the Up-down mode
among three options:
0 X
0 Increases goal frequency as a
standard of Max. frequency/Min.
frequency.
1 Increases as many as step
frequencies according to edge
input.
2 Available to combine 1 and 2.
1):
It is shown when F63 is set to 1.