Santerno Sinus M, User Manual

Page: 51 / 219

7-1
CHAPTER 7 - FUNCTION LIST
7.1 Drive group
LED
display
Parameter
name
Setting
range
Description
Factory
defaults
Adj.
during
run
0.00 [Frequency
command]
0 ~ 400
[Hz]
This parameter sets the frequency that
the inverter is commanded to output.
During Stop: Frequency Command
During Run: Output Frequency
During Multi-step operation:
Multi-step frequency 0.
It cannot be set greater than F21- [Max
frequency].
0.00 O
ACC [Accel time] 0 ~ 6000
[Sec]
During Multi-Accel/Decel operation, this
parameter serves as Accel/Decel time
0.
5.0 O
dEC [Decel time] 10.0 O
drv [Drive mode] 0 ~ 3
0 Run/Stop via Run/Stop key on the
keypad
1 X
1
Terminal
operation
FX: Motor forward run
RX: Motor reverse run
2
FX: Run/Stop enable
RX: Direction
3 RS485 communication
Frq [Frequency
setting
method]
0 ~ 8 0
Digital
Keypad setting 1 0 X
1 Keypad setting 2
2
Analog
V1 1: –10 ~ +10 [V]
3 V1 2: 0 ~ +10 [V]
4
Terminal I: 0 ~ 20
[mA]
5
Terminal V1 setting 1
+ Terminal I
6
Terminal V1 setting 2+
Terminal I
7 RS485
8 Digital Volume (Up-Down)
REF PID Ref - Displays PID reference - -
FBK
PID
Feedback
- Displays PID Feedback - -
St1 [Multi-Step
frequency 1]
0 ~ 400
[Hz]
Sets Multi-Step frequency 1 during
Multi-step operation.
10.00 O
St2 [Multi-Step
frequency 2]
Sets Multi-Step frequency 2 during
Multi-step operation.
20.00 O
St3 [Multi-Step
frequency 3]
Sets Multi-Step frequency 3 during
Multi-step operation.
30.00 O
CUr [Output
current]
Displays the output current to the
motor.
- -