Santerno Sinus M, User Manual

Page: 82 / 219

9-4

Frequency setting via 0 ~ 10 [V] input or Terminal Potentiometer
Group Code Parameter Name Setting Range Initial Unit
Drive group 0.00 [Frequency Command] - 0 ~400 0.00 Hz
Frq [Frequency Mode] 3
0 ~ 8 0
I/O group I6
[Filter time constant for V1
input]
10 0 ~ 9999 10
I7
[V1 input Min voltage]
- 0 ~ 10 0 V
I8
[Frequency corresponding
to I7]
- 0 ~ 400 0.00 Hz
I9
[V1 input max voltage]
- 0 ~ 10 10 V
I10
[Frequency corresponding
to I9]
- 0 ~ 400 50.00 Hz

Select 3 in Frq code of Drive group.

0-10V can be directly applied from an external controller or a potentiometer connected on
terminals VR, V1 and CM.

Wire the terminals as shown below and refer to page 9-3 for I6 ~ I10.

Frequency setting via 0 ~ 20 [mA] input
Group Code Parameter Name Setting Range Initial Unit
Drive
group
0.00 [Frequency Command] - 0 ~400 0.00 Hz
Frq [Frequency Mode] 4 0 ~ 8 0
I/O
group
I11
[Filter time constant for I input]
10 0 ~ 9999 10
I12
[I input minimum current]
- 0 ~ 20 4 mA
I13
[Frequency corresponding to I12] -
0 ~ 400 0.00 Hz
I14
[I input max current]
- 0 ~ 20 20 mA
I15
[Frequency corresponding to I14] -
0 ~ 400 50.00 Hz

Select 4 in Frq code of Drive group.

Frequency is set via 0~20mA input between I and CM terminal.
VR
V1
CM
Wiring of potentiometer
V1
CM
0 ~ 10V input via external controller