Santerno Sinus M, User Manual

Page: 41 / 219

5-7
5.5 Parameter setting

Changing parameter values in Drive Group
When changing ACC time from 5.0 sec to 16.0 sec
Drive group
1
-. In the first code “0.00”, press the Up (

) key once to go to the second
code.
2
-. ACC [Accel time] is displayed.
-. Press the Ent key (

) once.
3
-. Preset value is 5. 0 , and the cursor is in the digit 0 .
-. Press the Left (

) key once to move the cursor to the left.
4 -. The digit 5 in 5 .0 is active. Then press the Up (

) key once.
5
-. The value is increased to 6 .0
-. Press the Left (

) key to move the cursor to the left.
6
-.
0
.60 is displayed. The first
0
in
0
.60 is active.
-. Press the Up (

) key once.
7
-. 1 6.0 is set.
-. Press the Ent (

) key once.
-. 1 6.0 is blinking.
-. Press the Ent (

) key once again to return to the parameter name.
8 -. ACC is displayed. Accel time is changed from 5.0 to 16.0 sec.
♣ In step 7, pressing the Left (

) or Right (

) key while 16.0 is blinking will disable the
setting.
Note 1) Pressing the Left (

)/ Right (

) /Up (

) /Down (

) key while cursor is blinking will cancel
the parameter value change. Pressing the Enter key (

) in this status will enter the value into
memory.