Omron FQ2-S/CH Series, User Manual, Page: 459 / 590

Menu Tables FQ2-S/CH User’s Manual
457
Appe
ndi
ce
s
9
In
spect
ion
D
et
a
ils
(Sh
ape search I
I*
2
S
hape
sear
ch
I
II
*
2
)
Mode
l p
aramet
e
r Rotation
(Only for Shape
Search lll)
Sets the angle range for the registered
model.
No
Yes (Default) Scene p. 238
Angle range
− 180 to 180
(Defaults: Lower limit: − 180
Upper limit: 180)
Scene p. 238
Model mode
You can change to a mode that makes
it easier to search for images similar to
a model. Fast
Stable (Default)
Scene p. 223
Meas. Pa
ramet
er Extraction condi-
tion
Scene
p. 237
Candidate
level Sets the detection target to only
objects with a correlation above the
specified candidate level. 0 to 100
Default
Shape Search ll: 80
Shape Search lll: 50
Scene
Extraction X
Results are output only for objects with
a measured X coordinate that is within
this range.
− 999,999,999.9999 to 999,999,999.9999
(Defaults:
Lower limit:
− 999,999,999.9999,
Upper limit: 999,999,999.9999)
Scene
Extraction Y
Results are output only for objects with
a measured Y coordinate that is within
this range.
− 999,999,999.9999 to 999,999,999.9999
(Defaults:
Lower limit:
− 999,999,999.9999,
Upper limit: 999,999,999.9999)
Scene
Detection
count
Sets the maximum number of detec-
tion results to output. 1 to 32
Default : 1
Scene
Sorting method
Sets the sort condition to use when
multiple measurement results meet
the extraction conditions..
Corr. ascending order
Corr. descending order (Default)
Pos.X ascending order
Pos.X descending order
Pos.Y ascending order
Pos.Y descending order
Scene p. 235
Overlay
Judgment
(only for Shape
Search lll) When you want to find the detected
result when the detected result is over-
lapped, set this parameter to ON.
ON
OFF (Default) Scene
p. 236
Overlay
Rejection
(only for Shape
Search lll) Set the range to remove overlapped
target.
0 to 100 (Default: 100) Scene
Edger level auto
(only for Shape
Search lll) The [Edge level] can be set automati-
cally by selecting ON.
If edge recognition results are not
good with this setting, set to OFF.
ON (Default)
OFF Scene
p. 239
Edge level
(only for Shape
Search lll)
This function will be enabled if you un-
check [Auto] check box.
Set the lower limit to recognize the
[Edge level]. Edges higher than set
value are recognized.
Decrease the setting value when it is
difficult to find edges.
Increase the setting value when the
effect of noise is high.
0 to 1024 (Default: 70) Scene
Acceptable Dist.
Level
(only for Shape
Search lll)
Set the acceptable level of distortion.
Low
Medium
High
Scene p. 240
Ou
tp
u
t p
a
ra
m
e
te
r
Reflect
You can specify whether to reflect the
judgement results of an inspection
item in the overall judgement. No
Yes (Default)
Scene p. 238
Menu command Description Setting range Data