Omron FQ2-S/CH Series, User Manual, Page: 392 / 590

Connecting to More Than One Sensor
390
FQ2-S/CH User’s Manual
Specifying Sensor Display Positions for Multiple Sensors ([Multi Sensor] or [Auto] Only)
If [Startup screen type] is set to [Multi sensor] or [Auto],*1 you can specify the position of the image on a split
display for each Sensor that is displayed.
*1 This can only be specified when at least two Sensors have been connected.
(Run Mode)
−
[Sensor monitor]
−
[Multi sensor]
or
(Run Mode) − [Switch sensor]
1
Press [
] −
[Display position] on the right of the dis-
play.
2
Press the display of the Sensor for which to specify
the display position. A list of numbers for the display
positions will be displayed.
3
Select a number from the list of display positions. The
display for the Sensor will be displayed in the posi-
tion that corresponds to the specified number.
The display positions that are set with [Display position] are cleared when the power supply to the Touch Finder is
turned OFF.
However, if the Sensor status is changed (by changing from Setup Mode to Run Mode), the current settings for [Dis-
play position] are saved in the Touch Finder. Therefore, the next time the same Sensors are connected, they will be
displayed in the same positions.
If a previously connected Sensor is not detected, either the display position will be blank, or if [Auto sensor detec-
tion] is set to [ON], the Touch Finder will display another Sensor that it has detected.
If a previously connected Sensor is then detected by the Touch Finder, it will display the image from it in the previous
display position.
Note