Usage Information
For more information about VLANs and the commands to configure them, see
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs and IP ACLs are supported. For more
information, see
.
The following features are not supported on VLANs associated with an OpenFlow instance:
•
IPv4
•
IPv6
•
MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled simultaneously.
Example (Single
Range)
Dell(conf)# int vlan 3
Dell(conf-if-vl-3)#
Related Commands
•
— configure a physical interface.
•
— configure a loopback interface.
•
— configure a null interface.
•
— configure a port channel group.
•
— display the current VLAN configuration on the switch.
•
— disable/enable the VLAN.
•
— add a Layer 2 interface to a VLAN as a tagged interface.
•
— add a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled, use the no
intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Enabled on the 100G interfaces
Command Modes
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
686
Interfaces