Usage Information
The
monitor
command is saved in the running configuration at Monitor Session mode level and can be restored
after a chassis reload.
Example
Dell# show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL
------ ------ ----------- --- ---- --------- -------- ---- ---
0 Te 1/1/2/1 remote-ip rx Flow 1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow 1.1.1.1 7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1 3.1.1.2 0 255
Related Command
•
— displays the monitor session.
•
show running-config monitor session
— displays the running configuration of a monitor session.
rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit
limit
To remove the limit, use the
no rate-limit
limit
command.
Parameters
limit
Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Defaults
60
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.8(0.0)
Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, Z9500.
Related Commands
•
— enable a monitoring session.
•
— display the monitor session.
show config
Display the current monitor session configuration.
Syntax
show config
Defaults
none
Command Modes
MONITOR SESSION (conf-mon-
sess-session-ID
)
1228
Port Monitoring