Dell S6100, Configuration Manual

Page: 54 / 1743

PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
ip prefix-list
command and the name for the prefix list. The prompt changes to include
conf-nprefixl
.
You can return to CONFIGURATION mode by using the
exit
command.
PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, see GARP VLAN
Registration (GVRP) .
To enter PROTOCOL GVRP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
protocol gvrp
command. The prompt changes to include
config-gvrp
.
You can return to CONFIGURATION mode by using the
exit
command.
RAPID SPANNING TREE (RSTP) Mode
To enable and configure RSTP, use RSTP mode. For more information, see Rapid Spanning Tree Protocol (RSTP) .
To enter RSTP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
protocol spanning-tree rstp
command. The prompt changes to include
conf-rstp
.
You can return to CONFIGURATION mode by using the
exit
command.
ROUTE-MAP Mode
To configure a route map, use ROUTE-MAP mode.
To enter ROUTE-MAP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the
route-map map-name [permit | deny] [ sequence-number ]
command. The prompt changes to include
config-route-map
.
You can return to CONFIGURATION mode by using the exit command.
ROUTER BGP Mode
To enable and configure Border Gateway Protocol (BGP), use ROUTER BGP mode. For more information, see Border Gateway Protocol
IPv4 (BGPv4)
To enter ROUTER BGP mode:
54 CLI Basics