Dell S6100, Configuration Manual

Page: 666 / 1743

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell# clear dampening tegigabitethernet 1/1/3/1
Clear dampening counters on TeGi 1/1/3/1 [confirm] y
Dell#
Related Commands
• show interfaces dampening — display interface dampening information.
• dampening — configure dampening on an interface.
dampening
Configure dampening on an interface.
Syntax dampening [[[[ half-life ] [ reuse-threshold ]] [ suppress-threshold ]] [ max-
suppress-time ]]
Parameters
half-life Enter the number of seconds after which the penalty is decreased. The penalty decreases
half after the half-life period expires. The range is from 1 to 30 seconds. The default is
5
seconds .
reuse-threshold Enter a number as the reuse threshold, the penalty value below which the interface state
is changed to “up”. The range is from 1 to 20000. The default is
750 .
suppress-threshold Enter a number as the suppress threshold, the penalty value above which the interface
state is changed to “error disabled”. The range is from 1 to 20000. The default is
2500 .
max-suppress-time Enter the maximum number for which a route can be suppressed. The default is four
times the half-life value. The range is from 1 to 86400. The default is
20 seconds .
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
666 Interfaces