Ipmacacl
number
Enter the keyword
ipmacacl
and then the number of FP blocks for IP and MAC ACL.
The range is from 0 to 9.
etsacl
number
Enter the keyword
etsacl
and then the number of FP blocks for ETS ACL. The range is
from 0 to 9.
nlbclusteracl
number
Enter the keyword
nlbclusteracl
and then the number of FP blocks for nlbcluster
ACL. The range is from 0 to 9. By default, the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
NOTE:
When you reconfigure CAM allocation, use the
nlbclusteracl
number
command to change the number of NLB ARP entries. The range is
from 0 to 9. The default value is 0. At the default value of 0, eight NLB ARP
entries are available for use. This platform supports up to 512 CAM entries.
Select 1 to configure 256 entries. Select 2 to configure 512 entries. Even
though you can perform CAM carving to allocate the maximum number of
NLB entries, Dell Networking recommends that you use a maximum of 64 NLB
ARP entries.
vman-qos
Enter the keyword
vman-qos
and then the number of FP blocks for VMAN QoS. The
range is from 0 to 9.
Ipv4pbr
number
Enter the keyword
ipv4pbr
and then the number of FP blocks for ipv4pbr ACL. The
range is from 0 to 8.Each PBR entry is carved out in double wide mode. While carving,
specify only even groups for PBR.
Openflow
number
Enter the keyword
openflow
and then the number of FP blocks for open flow. The
range is from 0 to 9 in multiples of 3.
fcoeacl
number
Enter the keyword
fcoeacl
and then the number of FP blocks for FCOE ACL. The
range is from 0 to 8 in multiples of 2.
Iscsioptacl
number
Enter the keyword
iscsioptacl
and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 9.
l2acl
number
ipv4acl
number
ipv6acl
number
,
ipv4qos
number
l2qos
number
l2pt
number
ipmacacl
number
{nlbclusteracl]
[vman-qos | vman-
dual-qos
number
]
ipv4pbr
number
openflow
{4|8} | fcoe
number
[iscsioptacl
number
]
[vrfv4acl
number
]
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
•
4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the
14 entries reserved for internal functionality)
•
8: Creates 498 entries for use by the OpenFlow controller (512 total entries minus the
14 entries reserved for internal functionality)
The fcoe range is 0–8 groups. Each group has 256 entries; the value given must be an
even number. This information is stored in the NVRAM and is effective after rebooting the
switch.
ipv4udfmirracl
Enter the keyword
ipv4udfmirracl
and then the number of FP blocks for IPv4 UDF
mirror ACL. The range is from 0 to 8.
Command Modes
CONFIGURATION
454
Content Addressable Memory (CAM)