Parameters
ip-address
Specify an IP address in dotted decimal format.
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
pre-6.1.1.0
Introduced on the E-Series.
Usage Information
If you configure the
set next-hop
command, its configuration takes precedence over the
neighbor next-
hop-self
command in the ROUTER BGP mode.
If you configure the
set next-hop
command with the interface’s IP address (either Loopback or physical), the
software declares the route unreachable.
Related Commands
•
— redistribute routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the
no set origin
command.
Parameters
egp
Enter the keyword
egp
to set routes originating from outside the local AS.
igp
Enter the keyword
igp
to set routes originating within the same AS.
282
Access Control Lists (ACL)
