[Document Title Name Goes Here]
R900 Installation Guide
The R900 bill validator is designed to fit into the standard bill acceptor opening
in most vending machines and can be mounted on existing studs or a mounting
bracket
Features
-
Four way bill acceptance
-
Multi-width bill handling mechanism
-
Lockable security cashbox (lockable) available
Interface
-
The R900 bill validator operates via MDB interface
-
PC base; RS232C interface CCNET protocol is also available
Operating Voltage
-
34VDC/24VDC for MDB interface
-
12VDC for CCNET interface (RS232C base)
INSTALLATION
Before installation, remove the R900 bill validator from the packaging and inspect for any physical damage. If damaged, contact
technical support
1.
Turn off power from the vending machine.
2.
Remove the bill magazine. Press forward on the yellow latch on the bill magazine and pull to remove.
3.
Mount the R900 bill validator on the mounting studs, through the opening in the front of the vendor and secure using the included
hardware.
4.
Connect the R900 bill validator to the appropriate interface harness. Apply gentle pressure to connect; the pins will bend if forced.
5.
Turn on power to the vending machine.
6.
Check the arrow LED on the front of R900. The LED should be flashing. In some cases, the machine door must be closed first.
7.
Once the LED is flashing, test the validator with a bill.
a.
Insert a bill and confirm that it stacks and credit is given
b.
Repeat this process for any other enabled bills.
8.
When your test is completed, remove the test bills from the bill magazine.
The installation is now complete. Refer to the other sections of this guide to configure the device, if necessary.
