Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
Usage Information
IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP source to regenerate the
message. A cycle of purging and regenerating LSPs can occur when a network link continues to deliver accurate
LSPs even though there is a link causing data corruption. This process could cause disruption to your system
operation.
ip router isis
Configure IS-IS routing processes on an interface and attach an area tag name to the routing process.
Syntax
ip router isis [
tag
]
To disable IS-IS on an interface, use the
no ip router isis [
tag
]
command.
Parameters
tag
(OPTIONAL) The tag you specify identifies a specific area routing process. If you do not
specify a tag, a null tag is assigned.
Defaults
No processes are configured.
Command Modes
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
7.5.1.0
Introduced.
Usage Information
To assign a network entity title to enable IS-IS, use the
net
command.
This command accepts even if an IP address is not configured. This command is cached in the L3 Manager till the
IP address is configured. When the IP address configuration reaches the L3Manager, the circuit add message is
sent to IS-IS.
Intermediate System to Intermediate System (IS-IS)
861