Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
pre- 7.7.1.0
Introduced.
Related Commands
•
— creates an input policy map.
•
— creates an output policy map.
•
— creates an input QoS-policy on the router.
•
— creates an output QoS-policy on the router.
•
— creates a WRED profile.
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
NOTE:
IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any class-maps on both ACLs
as well as VLANs.
Syntax
match ip access-group
access-group-name
[set-ip-dscp
value
| set-color
value
]
To remove ACL match criteria from a class map, use the
no match ip access-group access-group-
name [set-ip-dscp
value
| set-color
value
]
command.
Parameters
access-group-name
Enter the ACL name whose contents are used as the match criteria in determining if
packets belong to the class the class-map specifies.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP DSCP value. The matched
traffic is marked with the DSCP value. The range is from 0 to 63.
set-color
value
(Optional) Enter the keyword set-color followed by a color value. Traffic that fulfills the
match criteria is marked with the color value that you specify. The default value is Green.
Defaults
none
Command Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Quality of Service (QoS)
1269