Usage Information
The input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or incoming
packets DSCP. This command enables Policy-Map-Input Configuration mode (conf-policy-map-in). When you
configure an input policy map for CoPP, you must enter the keyword cpu-qos .
Related Commands
•
— assigns a class map and QoS policy to different queues.
•
— applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
Syntax
policy-map-output
policy-map-name
To remove a policy map, use the
no policy-map-output
policy-map-name
command.
Parameters
policy-map-name
Enter the name for the policy map in character format (32 characters maximum).
Defaults
none
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Policy name character limit increased from 16 to 32.
7.6.1.0
Introduced on the C-Series and S-Series.
6.1.1.1
Introduced on the E-Series.
Usage Information
To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables Policy-
Map-Output Configuration mode (conf-policy-map-out).
1278
Quality of Service (QoS)