Dell S6100, Configuration Manual

Page: 56 / 1743

SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information, see Spanning Tree Protocol (STP) .
To enter SPANNING TREE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
protocol spanning-tree
stp-id command. The prompt changes to include
conf-stp
.
You can return to CONFIGURATION mode by using the
exit
command.
SupportAssist Mode
To enable and configure the SupportAssist, use SupportAssist mode. For more information, see SupportAssist .
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
support-assist
command. The prompt changes to include
conf-supportassist
.
You can return to CONFIGURATION mode by using the
exit
command.
TRACE-LIST Mode
To configure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
ip trace-list
command, and the name of the Trace list. The prompt changes to include
conf-trace-acl
.
You can exit this mode by using the
exit
command.
VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, see Virtual Link Trunking (VLT) .
To enter VLT DOMAIN mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
vlt domain
command, and then the VLT domain number. The prompt changes to include
conf-vlt-domain
.
You can return to CONFIGURATION mode by entering the
exit
command.
VRRP Mode
To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information, see Virtual Router
Redundancy Protocol (VRRP) .
To enter VRRP mode:
1 To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
56 CLI Basics