Spanning Tree Protocol (STP)
The commands in this section configure and monitor the IEEE 802.1d spanning tree protocol (STP) and are supported on the Dell
Networking switch/routing platform.
Topics:
•
•
•
•
•
•
•
•
•
•
•
•
bridge-priority
Set the bridge priority of the switch in an IEEE 802.1D spanning tree.
Syntax
bridge-priority {
priority-value
| primary | secondary}
To return to the default value, use the
no bridge-priority
command.
Parameters
priority-value
Enter a number as the bridge priority value. The range is from 0 to 65535. The default is
32768
.
primary
Enter the keyword
primary
to designate the bridge as the root bridge.
secondary
Enter the keyword
secondary
to designate the bridge as a secondary root bridge.
Defaults
priority-value =
32768
Command Modes
SPANNING TREE (The prompt is “config-stp”.)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
52
1564
Spanning Tree Protocol (STP)
