Dell S6100, Configuration Manual

Page: 1572 / 1743

Related Commands
• disable — disables spanning tree group 0. To enable spanning tree group 0, use the
no disable
command.
show config
Display the current configuration for the mode. Only non-default values display.
Syntax show config
Command Modes SPANNING TREE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-stp)# show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group configuration and status of interfaces in the spanning tree group.
Syntax show spanning-tree 0 [active | brief | guard | interface interface | root |
summary]
Parameters
0 Enter
0
(zero) to display information about that specific spanning tree group.
active (OPTIONAL) Enter the keyword
active
to display only active interfaces in spanning tree
group 0.
1572 Spanning Tree Protocol (STP)