offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
Syntax
offset-list
prefix-list-name
{in | out}
offset
[
interface
]
To delete an offset list, use the
no offset-list
prefix-list-name
{in | out}
offset
[
interface
]
command.
Parameters
prefix-list-name
Enter the name of an established Prefix list to determine which incoming routes are
modified.
offset
Enter a number from zero (0) to 16 to be applied to the incoming route metric matching
the access list specified. If you set an offset value to zero (0), no action is taken.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then
the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE
then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the stack/
slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE
then the stack/
slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
•
For a VLAN, enter the keyword
vlan
then a number from 1 to 4094.
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
Routing Information Protocol (RIP)
1333
