Input Statistics:
10 packets, 10000 bytes
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 10 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
1 packets, 64 bytes, 0 underruns
1 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 1 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:04:59
Dell#
show interfaces dampening
Display interface dampening information.
Syntax
show interfaces dampening [[
interface
] [summary] [detail]]
Parameters
interface
(Optional) Enter one of the following keywords and the interface information:
•
For a port channel interface, enter the keywords
port-channel
then a number.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then
the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE
then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the stack/
slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE
then the stack/
slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
NOTE:
This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation
for specifying port range in the command is different from how you specify in
non-ON platforms.
•
For non-ON platforms, you can specify multiple ports as
slot/port-range
. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as
show interfaces
interface-type
1/1 - 4
.
•
For ON platforms, you can specify multiple ports as
slot/port/[subport] -
slot/port/[subport]
. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as
show
interfaces
interface-type
1/1/1 - 1/1/4
.
summary
(OPTIONAL) Enter the keyword
summary
to display the current summary of dampening
data, including the number of interfaces configured and the number of interfaces
suppressed, if any.
Interfaces
707
