Yamaha WR250F(N), Руководство по эксплуатации для владельца

Страница: 668 / 686

7 - 17
T U N
EC72B000
Rear suspension setting
The rear suspension setting should be made
depending on the rider’s feeling of an actual
run and the circuit conditions.
The rear suspension setting includes the fol-
lowing two factors:
1. Setting of spring preload
●
Change the set length of the spring.
●
Change the spring.
2. Setting of damping force
●
Change the rebound damping.
●
Change the compression damping.
EC72C001
Choosing set length
1. Place a stand or block under the engine
to put the rear wheel above the floor, and
measure the length
a
between the rear
wheel axle center and the rear fender
holding bolt.
2. Remove the stand or block from the
engine and with a rider astride the seat,
measure the sunken length
b
between
the rear wheel axle center and the rear
fender holding bolt.
3. Loosen the locknut 1 and make adjust-
ment by turning the spring adjuster 2 to
achieve the standard figure from the sub-
traction of the length
b
from the length
a
.
Standard figure:
90 ~ 100 mm (3.5 ~ 3.9 in)
SETTING