Mitsubishi Electric MR-J4 TM Series, Инструкция по эксплуатации

Страница: 73 / 594

1. FUNCTIONS AND CONFIGURATION
1 - 56
(3) 100 V class
The diagram is for MR-J4-20TM1.
CN4
CN5
MR Configurator2
CN8
CN2
CN2L (Note 4)
CN3
W
V
U
P+
C
L11
L21
L1
L2
Power factor
improving AC
reactor
(FR-HAL)
R T
(Note 1)
D (Note 5)
Network module dependence (Note 6)
Junction terminal
block
To safety relay or MR-J3-D05
safety logic unit
Battery
Servo motor
(Note 3)
Magnetic
contactor
(MC)
(Note 1)
Molded-case
circuit breaker
(MCCB)
(Note 2)
Power supply
Line noise
filter
(FR-BSF01)
Regenerative
option
Personal
computer
Note 1. The power factor improving DC reactor cannot be used.
2. For power supply specifications, refer to section 1.3.
3. Depending on the main circuit voltage and operation pattern, bus voltage decreases, and that may cause the forced stop
deceleration to shift to the dynamic brake deceleration. When dynamic brake deceleration is not required, slow the time to turn
off the magnetic contactor.
4. When using servo amplifier in the fully closed loop system, connect an external encoder to this connector. Refer to Table 1.1
and Linear Encoder Instruction Manual for the compatible external encoders.
5. Always connect between P+ and D terminals. When using the regenerative option, refer to section 11.2.
6. For the network module connections, refer to the MR-J4-_TM_ Servo Amplifier Instruction Manual for each communication
method.