Mitsubishi Electric MR-J4 TM Series, Инструкция по эксплуатации

Страница: 58 / 594

1. FUNCTIONS AND CONFIGURATION
1 - 41
(1) Installation of network module
1) Remove the slot cover with a flat-blade screwdriver, etc.
Make sure to store the removed cover.
Press it against the
board and insert.
2) Press the network module against the board on the right
side so as to align with the guide in the servo amplifier, and
insert it along the board.
Forcibly inserting it all the way in obliquely without aligning
with the guide may break the board and the network
module.
Check that the network module
tab can be confirmed through
the confirmation hole in the
same manner as the upper hole.
Network module
tab
Confirmation
hole
The network module tab hits the
board end face, and the module
is incompletely inserted.
Check that the network module
tab can be confirmed through
the confirmation hole.
The network
module tab
cannot be
confirmed
through the
confirmation
hole.
Fixing screw
(6-lobe screw)
3) Check if the network module tabs can be confirmed
through the confirmation hole on the side of the servo
amplifier as shown in the diagram.
If the tabs cannot be confirmed, insert the network module
while pressing it since the tabs hit the board end face, and
the module is incompletely inserted.
4) Tighten the fixing screws using a #8 6-lobe driver.
Tightening torque is 0.25 N•m.