Mitsubishi Electric MR-J4 TM Series, Инструкция по эксплуатации

Страница: 196 / 594

5. PARAMETERS
5 - 57
No./
symbol/name
Setting
digit
Function
Initial
value
[unit]
Network
ECT EIP
PD12
*DOP1
Function
selection D-1 _ _ _ x For manufacturer setting 1h
_ _ x _ 0h
_ x _ _ 1h
x _ _ _ Servo motor thermistor enabled/disabled selection
0: Enabled
1: Disabled
The setting in this digit will be disabled when you use a servo motor without
thermistor.
0h
PD13
*DOP2
Function
selection D-2
_ _ _ x For manufacturer setting 0h
_ _ x _ 0h
_ x _ _ INP (In-position) on condition selection
Select a condition for turning on INP (In-position).
0: Within the in-position range
1: Within the in-position range and at the completion of command output
0h
x _ _ _ For manufacturer setting 0h
PD14
*DOP3
Function
selection D-3 _ _ _ x For manufacturer setting 0h
_ _ x _ Selection of output device at warning occurrence
Select WNG (Warning) and ALM (Malfunction) output status at warning occurrence.
Servo amplifier output
0h
Setting
value
(Note 1) Device status
0
0
1
0
1
WNG
ALM
Warning occurrence
1
0
1
0
1
WNG
ALM
Warning occurrence (Note 2)
Note 1. 0: Off
1: On
2. Although ALM is turned off upon occurrence of the warning, the forced
stop deceleration is performed.
_ x _ _ For manufacturer setting 0h
x _ _ _ 0h
PD37
*TPOP
Touch probe
function
selection _ _ _ x Touch probe higher precision selection
Latches the rising of TPR2 correctly, and detects it with an accuracy of 2 µs.
0: Disabled
1: Enabled
When "Enabled" is selected, encoder output pulses are disabled.
0h
_ _ x _ For manufacturer setting 0h
_ x _ _ 0h
x _ _ _ 0h
PD38
*TPR1
Touch probe
selection 1 _ _ x x Input signal function selection
Select an input device to be assigned to the CN3-10 pin.
2C: TPR1 (touch probe 1)
2E: ST (operation start-up)
The setting value "2E" is available with servo amplifiers with software version B0 or
later.
2Ch
_ x _ _ For manufacturer setting 0h
x _ _ _ 0h