HX7+ ASD Installation and Operation Manual
3
Equipment Inspection
•
Upon receipt of the equipment, inspect the packaging and equipment for shipping damage.
•
Carefully unpack the equipment and check for parts that may have been damaged during shipping,
missing parts, or concealed damage. If any discrepancies are discovered, it should be noted with the
carrier prior to accepting the shipment, if possible. File a claim with the carrier if necessary and
immediately notify your Toshiba Customer Support Center.
•
DO NOT
install the ASD if it is damaged or if it is missing any component(s).
•
Ensure that the rated capacity and the model number specified on the nameplate conform to the
order specifications.
•
Modification of this equipment is dangerous and is to be performed by factory trained personnel
ONLY
. When modifications are required contact your Toshiba Customer Support Center.
•
Inspections may be required after moving the equipment.
•
Contact your Toshiba Customer Support Center to report discrepancies or for assistance if required.
Handling and Storage
•
Use proper lifting techniques when moving the ASD; including properly sizing up the load, getting
assistance, and using a forklift if required.
•
Store in a well-ventilated location and preferably in the original packaging if the equipment will not
be used upon receipt.
•
Store in a cool, clean, and dry location. Avoid storage locations with extreme temperatures, rapid
temperature changes, high humidity, moisture, dust, corrosive gases, or metal particles.
•
The storage temperature range of the
HX7+ ASD
is -14° to 104° F or 122° F (-10° to 40° C or
50° C). Thermal specifications are model-specific.
•
DO NOT
store the unit in places that are exposed to outside weather conditions (i.e., wind, rain,
snow, etc.).
•
Store in an upright position.
Disposal
Never dispose of electrical components via incineration. Contact your state environmental agency for
details on disposal of electrical components and packaging in your area.
Summary of Contents for HX7+ ASD
