![background image](http://html1.mh-extra.com/html/nec/univerge-sv9100/univerge-sv9100_hardware-manual_3936970090.webp)
Issue 1.2
UNIVERGE SV9100
3 - 18
Installing the SV9100 Chassis
1.2.2
Install AC Power Cord 9.5” Gateway or Base Chassis
Locate the supplied AC power cord and attach to the AC Inlet located on the
back of the chassis [refer to
Figure 3-27 9.5” Chassis (Rear View)
].
1.2.3
Install Additional Blades 9.5” Gateway or Base Chassis
Refer to
Chapter 4,
2.1 Installation and Safety Precautions on page 4-3
.
1.2.4
Apply Power to the 9.5” Gateway or Base Chassis
Refer to Chapter 4,
2.6 Powering Up the SV9100 on page 4-9
.
1.3
Installing the 9.5” Chassis
The CHS2UG chassis has three universal blade slots for legacy line/trunk blade
(Single Line Telephone Interface, Digital multiline terminal Interface, Central Office
Trunk, ISDN PRI Interface, etc.), In-skin Application Blades (In-skin UMS, In-Skin
Router, etc.). It also houses the BUS Interface Blade and Power Supply Unit
(PSU).
When the GCD-CP10 blade is installed in slot 1 of the 9.5” Base Chassis, it is
called the controlling chassis.
The 9.5" Base chassis provides up to 16 trunk ports or 32 extension ports. An
Expansion Chassis can be installed to the right of the Controlling or Base Chassis
providing an additional 48 ports (40 trunk/ 80 stations maximum) and can include
any combination of stations and trunks below this number. With IP connections, a
maximum of 400 trunk ports (maximum of 256 talk paths supported depending on
the IPLE daughter board installed) and 896 station ports is possible.
è
A license is required to support the expanded ports.
S
ECTION
2
W
ALL
M
OUNTING
THE
C
HASSIS
2.1
Wall Mounting the 19” (CHS2UG) Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis (55 lbs per system chassis – including blades, cords, power supply, etc.).
The chassis is secured to the wall with a wall mount bracket. Ensure that enough
space is available to allow the installation of additional expansion chassis.
2.1.1
CHS2UG Chassis Wall Mount Installation
Summary of Contents for Univerge SV9100
