![background image](http://html1.mh-extra.com/html/nec/univerge-sv9100/univerge-sv9100_hardware-manual_3936970151.webp)
UNIVERGE SV9100
Issue 1.2
System Hardware Manual
3 - 79
6.
Reconnect AC power cable to rear of 9.5” chassis.
7.
To power on the 9.5” chassis, refer to Chapter 4,
2.6 Powering Up the
SV9100 on page 4-9
.
6.4.3
CHS LARGE BATT BOX Fuse Replacement
To replace the fuse(s) in the CHS LARGE BATT BOX, refer to Chapter 3,
section
6.2.4 CHS LARGE BATT BOX Fuse Replacement on page 3-67
.
S
ECTION
7
P
OWER
S
UPPLY
S
ECTION
8
R
EMOVE
AND
I
NSTALL
C
OOLING
F
AN
If required, the cooling fan installed in the CHS2UG chassis can be removed and
replaced. Follow the procedure below for the CHS2UG chassis.
8.1
CHS2UG Chassis
Figure 3-111 CHSG LARGE BATT BOX to CHS2UG Connection
Do not attempt to replace the power supply on the CHS2UG chassis. The
MPS7101 is not a field replaceable part. If the power supply fails, contact
NEC.
Summary of Contents for Univerge SV9100
