![background image](http://html1.mh-extra.com/html/nec/univerge-sv9100/univerge-sv9100_hardware-manual_3936970326.webp)
Issue 1.2
UNIVERGE SV9100
5 - 66
Installing DT Series Digital and IP Multiline Terminals
4.10 Adjusting the Height on the Multiline Terminal
The height of the DT series multiline terminals can be adjusted by moving the
legs attached to the bottom of the terminal.
1.
Turn telephone over (button side down).
2.
Adjust legs to desired height (refer to
Figure 5-55 Adjust Height of DT300/
DT700 Series Terminal
).
3.
Turn telephone over (button side up).
4.11 Removing or Installing the Tilt Legs on the Multiline Terminal
The Tilt Legs can be removed or installed on the DT Series multiline terminal.
4.11.1
Remove Tilt Legs
1.
Place the telephone on a flat surface (button side down).
2.
Separate the Tilt Legs and place them flat against the
Figure 5-58 Adjust Height of DT Series Terminal
Summary of Contents for Univerge SV9100
