Issue 1.2
UNIVERGE SV9100
3 - 78
Installing the SV9100 Chassis
6.4.2
CHS LARGE BATT BOX to 9.5” Chassis Connection
1.
Power down the CHS2U GW or CHS2UG chassis.
2.
Disconnect AC power cable from rear of chassis.
3.
From the back of the 9.5” chassis, remove the black plastic square
covering the two-prong battery terminal leads (refer to
Figure 3-110
9.5” Chassis (Rear View)
).
4.
Connect one end of Battery Connection Cable to Battery Connector on
rear of 9.5” chassis.
5.
Connect other end of cable to Battery Connector on rear of CHS
LARGE BATT BOX chassis (refer to
Figure 3-111 CHSG LARGE
BATT BOX to CHS2UG Connection on page 3-79
).
Ensure the CHS2UG GW-US or CHS2UG chassis is
powered OFF.
Figure 3-110 9.5” Chassis (Rear View)
Ground
AC Inlet
For External Battery
(12V Connection)
CHS2UG
Summary of Contents for Univerge SV9100
