![background image](http://html1.mh-extra.com/html/nec/univerge-sv9100/univerge-sv9100_hardware-manual_3936970375.webp)
UNIVERGE SV9100
Issue 1.2
System Hardware Manual
5 - 115
7.4.2
Wall Mounting the Bluetooth Cradle
Clearances required for installing the Bluetooth cradle are shown
below. Avoid mounting the cradle on a plaster-board wall, but before
mounting the cradle on a wall, check that the wall can withstand the
weight of the telephone and the load from pulling the telephone
during operation.
1.
Attach two wood screws to the wall.
.
Keep a clearance of about 0.08” (2mm) between each wood screw
and the wall (refer to
Figure 5-131 Installing Wood Screws on page
5-116
).
Figure 5-130 Wall Mount Spacing Guide BCH-L (BK) UNIT
To prevent possible damage to the BCH-L (BK)
UNIT due to falling, NEC recommends installing
the unit in a firm position so it will not fall due to its
own weight.
Summary of Contents for Univerge SV9100
