![background image](http://html1.mh-extra.com/html/nec/univerge-sv9100/univerge-sv9100_hardware-manual_3936970192.webp)
Issue 1.2
UNIVERGE SV9100
4 - 38
Installing the SV9100 Blades
4.2.2
Installation
The GPZ-8DLCB is installed on the GCD-8DLCA. To install:
1.
Connect the GPZ-8DLCB to the CN2 connector on the
GCD-8DLCA blade. Refer to
Figure 4-9 GCD-8DLCA/GCD-
16DLCA/ Blade on page 4-32
for the location of the connectors
on the blade.
2.
Install the GCD-8DLCA into a slot.
3.
Each CNx01 connector (CN101, CN201, CN301, CN401) is
used to connect up to four digital extensions.
4.2.3
GPZ-8DLCB Daughter Board Cable Connection
The GPZ-8DLCB blade has connections for CN301 and CN401
Refer to
for connector locations.
The following tables show the cable connections of the two RJ-61
connectors on the GPZ-8DLCB.
Table 4-17GPZ-8DLCB CN301 Connection
RJ-61 Cable Connector
CN301 (ports 9~12)
Pin No.
Connection
1
(T4) Tip for port 12
2
(T3) Tip for port 11
3
(T2) Tip for port 10
4
(R1) Ring for port 9
5
(T1) Tip for port 9
6
(R2) Ring for port 10
7
(R3) Ring for port 11
8
(R4) Ring for port 12
Summary of Contents for Univerge SV9100
